997 GT3 engine conversion 1000 hp

1000 hp (735 KW) at 7,300 rpm

1,100 Nm at 3,800 rpm

Consisting of:

• aluminum forged pistons with compression 8.0:1
• Engine block pinned and reinforced
• camshafts for "VarioCam"
• "sputter" connecting rod bearings
• Modified oil pressure control
• 6x BOSCH injectors
• Modified fuel pressure regulator
• 9FF hose set petrol system
• Additional Bosch Motorsport fuel pump "Intank"
• 2x Turbocharger G30 900 ball bearing and oil cooled
• Modified turbocharger mount for new position
• 9FF Teflon hose kit for turbocharger oil supply
• 2x turbocharger oil collection tank with accessories
• 9FF manifold stainless steel
• 9FF exhaust system polished stainless steel
• 9Ff tailpipes diameter 80 / 80mm stainless steel polished
• 2x 100cell metal motorsport catalytic converters
• intercooler 130mm with hose set
• intercooler suspensions with small parts
• Intercooler air ducts inside and outside
• Air filter box 997 Turbo with 9FF cover
• 2x bypass valves
• 9FF intake pipes with 80mm cross-section
• 9FF stainless steel Y-pressure pipe 60mm polished
• BMC air filter insert
• Lightweight single-mass flywheel cpl.
• 2-disc clutch complete with organic lining
• 997 Turbo engine control unit
• 9FF control unit programming with 3 boost pressure characteristics via switch
• 3 bar MAP sensor
• Motorsport spark plugs with 9FF special heat value
• exhaust gas temperature sensor set
• Reprogramming the speedometer unit for turbo operation
• boost pressure indicator
• Conversion of the vehicle electrics / wiring harness for turbo operation
• Castrol RS 10W-60 engine oil
• oil filter and gasket kit
• 6th gear 0.82: 1 (corresponds to 346 km/h Vmax.)

Only for 997 GT3 MK1 3.6 additionally:

• Auxiliary shaft modified to drive oil suction pump
• New water pump housing with integrated oil suction pump
• turbocharger oil extraction line harness

Only for 997 GT3 MK2 3.8 additionally:

• 2x camshaft boxes 997 GT3 MK1 with covers
• camshafts for turbo operation
• 2x exhaust shaft covers
• 1x Turbocharger oil suction pump with mounting material
• hose set oil extraction
• 6x new ignition coils
• Conversion of the electrics to a 3-pole ignition system including relays etc.
• 2x new sprockets for exhaust camshafts including accessories

This conversion can only be carried out by us in Dortmund!